Best Lab Equipment

Here are some more information for Micro Pump:

All you need to know about Heat Pump

WHAT IS A HEAT PUMP?

Heat pumps operate rather like a refrigerator in reverse - using the air surrounding it in order to gather heat for transfer.

Heat is gathered from air drawn through the unit, and transferred to the refrigerant carried in pipes through the Heat Pump and then the temperature is increased by compressing the refrigerant. The heat is then transferred to the pool water contained in adjacent piping.

ADVANTAGES:

The major advantage of electric heat pumps is that they are extremely energy efficient.

In simple terms, the heat pump consumes very little energy by way of electricity to operate, compared to the amount of energy it produces in the form of heat. For example, if a heat pump consumes 2 kW of electricity it will produce 6 to 10 kW of heat energy. This efficiency ratio is referred to as a C.O.P. (co-efficient of performance).

SIZING:

Heat Pumps can be obtained in a number of sizes ranging from 2 kW to 200 kW output. The one to suit your application will depend on careful consideration of the following factors:

• Location - local climatic conditions largely influence selection

• Temperature - your choice, however as a guide:-

1. Exercise and/or fun pool at - 24 to 28°C
2. Therapeutic exercise at - 28 to 35°C
3. Spa pool at - 34 to 38°C

• Size of Pool - determine the pool volume by multiplying the surface area in sq. meters by the average depth (including wading areas and spa). Select the appropriate unit for the volume of the pool.

• Shading & exposure to wind - these can affect the heat losses and gains of heated water

• Pool position - indoor or outdoor

• Swimming season - do you want to swim all year round or just extend the season?

INSTALLATION:

Heat Pumps can be installed indoors or outdoors. However, before deciding on the heaters position, consideration should be given to air flow and ventilation. The Heat Pump uses a fan to draw in air across a coil and then expels it. If positioned indoors, allow for this ventilation.

For outdoor installation the heater can be positioned at ground level (50mm plinth preferred), mounted on a wall or even sat on a roof.

Units can be included as part of the pump/filter network or plumbed as a separate heating circuit.

Average size domestic installations generally require a single phase electrical connection. Larger pools may require three phase power.

THINGS TO LOOK FOR:

All heat pumps should have some form of flow control device to prevent the unit operating without adequate water flow.

Heat Pumps are all thermostatically controlled. However these controllers may range from analogue dial type units to micro-processed digital devices. To the operator, all these types produce the same result, and that is to control the pool temperature to your desired setting. An advantage of the digital type is that the settings are displayed more clearly.

Naturally not all heat pumps are the same. Some may have features that others do not. Some manufacturers provide additional controls including time clock and/or pump interlock to ensure the most economical operation of the heat pump/pool pump.

Whatever your choice, make sure you deal with a SPASA member when the time comes to choose your swimming pool heat pump.

Warning:

When heat pumps are used on salt chlorinated pools, care should be taken to ensure the production of chlorine is adjusted to suit either the spa or pool, as excessive salt and/or chlorine levels can damage internal components. This is particularly important when operating for extended periods during heat-up.

About the Author

Aiden Thomas is the writer of this article. For more information about Heat Pump and Pool Pumps visit – http://www.poolexpress.com.au

How much will the " New " 12GB Micro SDHC Card be available...?

How much will the " New " 12GB Micro SDHC Card be available...

It should be hitting the marked anytime now, however it will probably cost an arm and a leg for the first little while.

Rudd picks fight with NSW over health reform
Prime Minister Kevin Rudd has accused New South Wales Labor politicians of pushing health bureaucrats to actively undermine his $50 billion hospitals reform program.

Thanks for visiting!