Best Lab Equipment

Here are some more information for Vacuum Flange Stainless:

Forsta New Green-Clean Automatic Water Filters Save Backwash Water

Forsta Filters Inc. has revolutionized the industrial water filter industry with the release of its Green-Clean technology, reducing backwash waste water by as much as 75%.

Without interrupting system flow during backwash, Green-Clean technology utilizes smaller flush valves to minimize the volume of water required to remove buildup on a filter element. Using internal vacuum nozzles, the new Green-Clean system scans and removes debris from the filter in 15 seconds or less. This combination of short duration and small flush valve make the Green-Clean backwash cycle one of the most efficient in the industry.

Forsta Filters offers a full line of self-cleaning water filters (1-36” flange size), with screen elements ranging from 5 to 4000 micron. Integrating the Green-Clean technology in all products maximizes efficiency and reduces waste water and energy costs. The filters are constructed from all stainless steel and are designed to provide a long term solution to a wide range of industrial and municipal applications.

For more information contact:
FORSTA FILTERS, INC.
www.forstafilters.com
Phone (888) 9-FORSTA (888-936-7782)
Fax (310) 837-6477
PO Box 341830
Los Angeles, CA 90034

About the Author

custom turbo for mustang?

i want to turbo my 1996 mustang v6 3.8 mustang. I found a kit online for 1500. Just want to know if this would be a good idea and what else I would need to put it on.
It comes with
- Custom Spec'd T28 Turbocharger
- Turbo Gasket Kit
- Turbo Water Line Kit
- Turbo Oil Line Kit
- Turbo Inlet Flange
- Turbo Outlet Vband Flange
- Turbo Vband Downpipe
- TurboKits.com Intercooler - 400HP
- (2) 2.5" 45 Degree Aluminum Pipe
- (2) 2.5" Straight Aluminum Pipe
- (6) 3 Ply Silicone Straight Couplers
- (2) 3 Ply Silicone 90 Degree Couplers
- (16) Stainless T-Bolt Clamps
- Forge Billett Aluminum BOV
- Air Intake Filter
- Boost Gauge
- D1 SPEC Turbo Timer
-4ft vacuum line
Other info
Boost: 8-20 PSI
HP Gain: Custom
Warranty: 1 Year

Looking to get 400 HP from a little 6 banger. It's possible but you must do more to the engine and car if you want it to last more than a couple of passes down the quarter mile.

First off this is a 15 year old car with a 15 year old engine, 15 year old transmission, 15 year old drive shaft, and 15 year old differential. If these are all factory original they will not be up to the task. Things are going to break and break hard. The engine, transmission, drive shaft, and differential need to be overhauled or upgraded before you even think about adding the turbocharger.

Consider this scenario. You add the turbo kit only but fail to upgrade the engine and the rest of the drive-line. You take your freshly turbocharged Mustang out on its maiden voyage. You pull up to a light. A mid 90's Z/28 pulls up along side you and revs the engine a couple of times. You start to drool because you are about to have fresh Camaro for lunch. You start to give your Mustang a little gas to spool up the turbo for launch. The light turns green. You put your right foot to the floor and slip your other foot off of the clutch. You hear a loud bang and go nowhere. Steam and smoke are starting to come from under the hood, fluids are coming out the bottom. Time for a tow truck. How embarrassing.

The stock cast crankshaft, rods, and pistons won't be up to the task. You will need to find a forged crankshaft, rods, and pistons. Also, when selecting your pistons you will want some turbocharger friendly ones. These usually have a smaller dome that will lower the compression ratio down to about 8.5:1 to reduce the detonation problems you will be constantly fighting under boost. With lower compression pistons you will be able to run the engine on premium 92 octane pump gas instead of hard to find and expensive racing fuel.

The rest of your 6 banger drive line won't be up to the task either. You may want to use the transmission and rear end from a Mustang GT. These are built to handle V8 power and should be good up to 400 HP.

Personally I think you would be better off selling this 6 banger mustang and getting a GT. There is much more potential with the V8. And you will find far more aftermarket goodies for the V8 than you will the 6 banger. You will literally get more bang for the buck hopping up a V8 Mustang.

K-Tron To Exhibit Pharmaceutical Conveying And Feeding Systems At Interphex 2011, March 29-31, Jacob Javits, NY, Booth ...
K-Tron will exhibit the latest sanitary feeding and pneumatic conveying equipment and systems at Interphex 2011, March 29-31, Jacob Javits Convention Center, New York City, booth 3637.

Thanks for visiting!